Inverting Amplifier =================== It is very easy to make an amplifier using an Operational Amplifier IC. The amplification factor is decided the ratio of two resistors. Objective --------- Wire an Inverting amplifier using an Op-Amp, like µA741 or OP07, and test it. Procedure --------- .. image:: schematics/opamp-inv.svg :width: 300px - Make the connections on bread board as shown in the figure. - Set WG amplitude to 80 mV and frequency to 1000 Hz - Enable A1 and A2, and set ranges to 1V - Enable the amplitude and frequency displays of A1 and A2. - Make connections and calculate the voltage gain from the output - Change gain by changing the resistor values. The amplitude gain and and the phase difference can be observed from the output below. .. image:: pics/opamp-inv-screen.png :width: 400px Discussion ---------- Using expEYES, it is not possible to study the high frequency response.