Measure resistance by comparison ================================ According to Ohm's law, current through a conductor and the potential difference between it's end are proportional. The constant of proportionality is called the resistance. Mathematically :math:`R =\frac{V}{I}`. When two resistors are connected in series, the current will be same through both. :math:`I=\frac{V_{1}}{R_{1}}=\frac{V_{2}}{R_{2}}`. if the value of one resistance and the voltage across both are known, the other resistance can be calculated from :math:`R_{1}=R_{2}\times\frac{V_{1}}{V_{2}}` Objective ---------- Find the value of an unknown resistance by comparing it with a known resistance, using the equations given above. Assume R1 is the unknown resistance and R2 is :math:`1000\Omega` .. image:: schematics/res-compare.svg :width: 300px Procedure --------- - Fix the two resisters in series on a bread board. - Connect the junction to A1 - Connect the other end of R2(:math:`1~k\Omega`) to Ground. - Connect one end of R1 to PV1 - Set PV1 to 4 volts. - Enable the Checkbutton on top right, to measure the DC voltage at A1. Current :math:`I = \frac{V_{A1}}{R_{2}}` and R1 can be calculated using :math:`R_{1} = \frac {V_{PV1} - V_{A1}}{I}`. Ohm's law in AC circuits ------------------------ It can be easily shown that this measurement can be done using AC also. We will use both A1 and A2 inputs here. - Fix the two resisters in series on a bread board. - Connect the junction to A2 - Connect the other end of R2(:math:`1~k\Omega`) to Ground. - Connect one end of R1 to both WG and A1 - Set WG to 1000Hz - Enable A1 and A2 - Enable the Cursor Check button to diplay the voltages at the cursor Taking voltage reading from the picture below, :math:`I = \frac{1.92}{1000}` and :math:`R1=\frac{3.01-1.92}{0.00192} = 576.7` .. image:: pics/res-compare-ac.png :width: 400px Discussion ---------- In this measurements we have made the assumption that no current flows in to A1 and A2. This is not true, they both have an input impedance of :math:`1M\Omega` . This will matter when we use resistance values of mega Ohms range. To illustrate this connect WG to A1 using a wire and the same signal to A2 through a :math:`1M\Omega` resistor. Try to explain the results using Ohm's law.