/* digital.c -- routines for manipulating the I/O pins. Copyright (C) 2008 Ajith Kumar, Inter-University Accelerator Centre, New Delhi and Pramode C.E, GnuVision.com. This program is free software; you can redistribute it and/or modify it under the terms of the GNU General Public License as published by the Free Software Foundation; either version 3, or (at your option) any later version. */ #include struct port_pin { volatile uint8_t* port; volatile uint8_t* input_reg; volatile uint8_t* dir_reg; uint8_t pin; }; static struct port_pin pmap[] = {{&PORTB, &PINB, &DDRB,0}, {&PORTD, &PIND, &DDRD, 0}, {&PORTC, &PINC, &DDRC, 0}}; /* * The following functions act on pin numbers 0 ... 20 on the * Phoenix-MDK board. These pins are mapped to the * corresponding ports by the `translate' function. */ /* * Pins belonging to Ports B,C and D are marked with serial numbers ranging * from 0 to 20 on the PCB. This routine translates those numbers into port * address and the actual pin number. Used for implementing simpler functions. */ static struct port_pin* translate(uint8_t pin) { if (pin <= 4) { // PB0 to PB4 are labelled from 0 to 4 pmap[0].pin = pin; return pmap; } else if (pin <= 12) { // PD0 to PD7 are labelled from 5 to 12 pmap[1].pin = pin - 5; return pmap + 1; } else if (pin <= 20) { // PC0 to PC7 are labelled from 13 to 20 pmap[2].pin = pin - 13; return pmap + 2; } else { // Invalid pin number will select the LSB of port B. return pmap; } } /* * Set direction of pin to `input' or `output' */ void make_pin_input(uint8_t pin) { struct port_pin *t = translate(pin); *(t->dir_reg) &= ~(1 << t->pin); } void make_pin_output(uint8_t pin) { struct port_pin *t = translate(pin); *(t->dir_reg) |= (1 << t->pin); } /* * For a PIN configured as input, setting/clearing the corresponding bit * of PORTX will enable/disable the corresponding pullup resistor. */ void enable_pullup(uint8_t pin) { struct port_pin *t = translate(pin); if(!(((*(t->dir_reg)) >> t->pin) & 1)) *(t->port) |= (1 << t->pin); } void disable_pullup(uint8_t pin) { struct port_pin *t = translate(pin); if(!(((*(t->dir_reg)) >> t->pin) & 1)) *(t->port) &= ~(1 << t->pin); } void set_high(uint8_t pin) { struct port_pin *t = translate(pin); *(t->port) |= (1 << t->pin); } void set_low(uint8_t pin) { struct port_pin *t = translate(pin); *(t->port) &= ~(1 << t->pin); } uint8_t read_pin(uint8_t pin) { struct port_pin *t = translate(pin); return ((*(t->input_reg)) >> (t->pin)) & 1; }