Transient response of LCR circuits ================================== .. image:: schematics/RLC-circuit.svg :width: 300px Closing the switch in the cicuit shown above will change the voltage across the capacitor. Depending on the relative values of L, C and R, the voltage may show oscillations or it may change in an exponential manner. Objective --------- Apply a step voltage to an LCR circuit. Capture and analyse the resulting voltage across the capacitor. Procedure --------- .. image:: schematics/RLCtransient.svg :width: 300px - Use the 3000 turn coil and :math:`0.1~\mu F` capacitor - Click on 5->0V STEP. Adjust x-axis and repeat if required. - FIT the graph to find the resonant frequency & Damping factor. - Repeat with increased capacitance and resistance values. .. image:: pics/RLCtransient-screen.png :width: 400px The values chosen are for an underdamped response. The coil has in inductance more than 100mH and a resistance of around :math:`500 \Omega`. To increase damping, you may add a series resistor, or use a larger value capacitor. Discussion ---------- Explore the oscillatory nature of L and C in series. Resonant frequency of series LC circuit is given by :math:`f_0 = 1/(2\pi\sqrt{LC})`. The damping factor is :math:`R/(2\sqrt{LC})`, and it is equal to 1 for critical damping. Depending upon the value of C/L and R, the response could be under-damped, critically-damped or over-damped. We have used the 3000 turn coil and a :math:`0,1~\mu F` capacitor. The voltage across the capacitor after a 5 to 0V step is shown in figure. The measured resonant frequency tallies with :math:`f = 1/(2\pi\sqrt{LC})`, within the component tolerance values. https://en.wikipedia.org/wiki/RLC_circuit