#!/bin/bash # Copyright 2010-2012 Thomas Schoebel-Theuer / 1&1 Internet AG # # Copying and distribution of this file, with or without modification, # are permitted in any medium without royalty provided the copyright # notice and this notice are preserved. This file is offered as-is, # without any warranty. ##################################################################### ## defaults for module pipe_spread ## ## pipe_spread: increase the region where the sector numbers ## are running about. ## ## WARNING! this will not increase the workingset behaviour, ## and has almost no effect on SSDs or virtual storage. ## However, it _may_ be useful for increasing the average seek distance ## at mechanical hard disks. Check the result! ## enable_pipe_spread ## ## Set to 0 or 1. Enable / disable this module. enable_pipe_spread=0 ## pipe_spread_factor ## ## How large the "working area" should get. pipe_spread_factor=2.0 ## pipe_spread_align ## ## Ensure that the result is aligned to these multiples of sectors. ## (every $pipe_spread_every steps). pipe_spread_align=8 # corresponding to 4k MMU size ## pipe_spread_offset ## ## Additional offset (added to resulting sector#) pipe_spread_offset=0